Google Analytics Alternative

RWW 42: TSDC Organizer Part 2

This week I start on the joinery for my organizer. The biggest problem I faced was how to cut angled, stopped dados in my base. The orientation I need for the dividers is opposite from my right tilt saw so I have to improvise to get this cut done. Watch and see how I overcame this obstacle.

Leave a Comment:

All fields with “*” are required

Mark Mazzo

Shannon,

Nice work on the Tansu. I like the design.

Interesting…I usually chamfer the end grain first and hen go to the long grain so that any tearout is removed. However, as I think about it, it seems that both methods will work!

You did scare me a little when rebating the stopped groves for the back at the table saw. I’m a bit leery of small pieces like that with my hand so close to the blade – maybe hand tools or the router table with a hand screw/clamp to hold the piece as you move it past the cutter?

–Mark
The Craftsman’s Path